Thursday, May 26th, 2011 at
12:00 pm
Sink Strainer Ads
More Info
I just dug up the slab under an old (30 year old) tiled shower, because it was like mud.
My question is about the drain flange. It’s the type that has a liner and then concrete is poured on top of it. once I have the concrete out, and the liner cut away, how should the flange pull out?
is it screwed in? should I be able to uscrew it, or is it something I’ll have to cut?
thanks
Related Blogs
Friday, October 29th, 2010 at
11:51 am
Sink Strainer Ads
More Info
putty under the flange, but in a few weeks it will start to leak again. It is only the left sink basin that leaks and the right side is where I keep standing dish water to soak the dishes, but it has never leaked. I change the water in it sometimes twice daily. I went to Lowe’s and got a solid brass basket and it lasted longer before it also began to drip. I noticed that it was loose to turn on the flange, so this time I tightened it more with a large pair of channel locks. Could that be the problem? that I did not tighten it enough?
Related Blogs
Wednesday, August 4th, 2010 at
3:02 pm
Saturday, April 10th, 2010 at
5:16 am
I can’t remove the strainer drain in my kitchen sink to install a disposal flange.
I have a spanner wrench, but I need to know if there are any tricks to getting the right leveage or what I can to do to get the cupling to move without spinning the whole drain.
Related Blogs
Thursday, April 1st, 2010 at
9:40 pm
i do have the chemistry sink with an opening that is about 3 inches.like that of a bar sink.i do have a faucet that has a pop up water stop.standard for bathroom.i think its 1 1/4 the problem is how do you make the smaller pop up with all the gaskets.fit the 3 inch opening.the plumber at the local store says they dont make such a flange…..it is like trying to get a pop up water stopper for your bathroom in a sink that is for a kitchen.."just smaller"..i have to beable to make a seal on the sink then put the pop up threw that "flange"…i dont want to give up then have to spend more on a new sink.or put in a bar sink strainer
Related Blogs
Sunday, March 14th, 2010 at
9:41 pm
bought. I can’t find a "set" that matches for the new sink. Not even sure how to buy. Are they all just a standard size?
Please help.
Related Blogs
Wednesday, March 10th, 2010 at
9:22 pm
Is it the plumbers putty placed under the flange lip, or the flat rubber washer on the underside, that is tightened on with the locking nut?I just really need help with this I am not sure how to put this on so it doesn’t leak and I need to get this taken care of very quickly but I am not sure if I am doing everything right.
Related Blogs